ZETSAW Waistern H-180 Kitchen Panel Belt Saw for Drywall – 175mm (6.9") Japanese Pull Saw

• Starts a cut in the middle of a panel — The fore-blade is specially ground to scratch through a board and pierce it. That means you can cut an opening in the middle of a kitchen panel, drywall, or smart board without drilling a pilot hole first.
• Made for man-made boards — Cuts kitchen wall panels, drywall, and plastic.
• Wears on your belt — Comes with a sheath you can draw from with one hand, and a clip-on belt loop that goes on and off without unthreading your belt.
• Ni-P plated blade — The blade carries a nickel-phosphorus plating.
• 175mm (6.9") blade, 17 TPI, 0.60mm thick — A short blade you can control in tight spots and overhead.
• Impulse-hardened teeth — ZETSAW was one of the first makers to adopt impulse-hardening, a heat treatment that keeps the teeth sharp longer. The teeth can't be resharpened, but the blade is replaceable.
• Made by Okada Hardware Mfg. Co., Ltd. — A Japanese saw maker founded in 1943, producing ZETSAW saws for professionals and everyday users alike.
• Ships from U.S. stock — In stock in California. No overseas wait, no customs.

SPECS
Blade Length: 175mm (6.9")
Pitch: 1.50mm (17 TPI)
Blade Thickness: 0.60mm
Material: Kitchen wall panel, drywall, plastic
Cutting: Pocket cutting (panel piercing fore-blade)
Blade Finish: Ni-P plated
Included: Sheath, clip-on belt loop
Replacement Blade: Available (No. 15215)